TURBOCHARGER GP 2598434 - Caterpillar

Upgrade The Firmware
To complete the upgrade of the CAESbasic system installation, you must perform several short procedures:
Update the option keys file (if required)
Save the display configuration
Update the display software
Update the GPS receiver firmware
Restore the display configuration
Update the GPS receiver configuration (if required)Updating the Option Keys File (if required)
If your option key has expired, perform the following procedure:
Do not insert the data card into the CD550 display.
Hold down the "OK" key as you turn on the CD550 display.The CD550 display is turned on by turning on the key start switch. This starts the display in "Configuration" mode.
Press "Menu".
Press "Setup Menu".
Press "Installation". The "Setup Menu-Installation" dialog screen will appear.
Insert the data card into the CD550 display.
Select the "Software Support Option" and press "OK".The option keys file on the data card (if any) is automatically applied. The dialog "Option Keys File Loaded" will appear.
Press "OK".The dialog "Software Support Option" will appear.
Check to see when the software support expires. If the expiration date is on or after 31 August 2003, then the option key is valid and the display software upgrade to version 5.01 can continue. Proceed to Step 11.If the expiration date is before 31 August 2003, then the option key must be updated. Proceed to Step 10.
If you know the option key, use the arrow keys in order to manually enter the option key into the "Option Key" field. Press "OK" in order to apply the option key and update the expiration date.If the option key is not known, contact your Caterpillar dealer. Your support agreement may not be current. Do not continue with the upgrade until the expiration date is valid.
Press "ESC" in order to return to the dialog "Setup Menu - Installation".Saving the Display Configuration
Press "Config.".The dialog "Setup Menu - Configuration" will appear.
Select "Save Display Configuration" and press "OK".
Press "OK" again in order to save the machine's display configuration file (for example, Dozer 01) to the data card.Updating the Display Software
Cycle power on the CD550 display.Do this by turning the key start switch to the OFF position, wait for the display screen to go blank (approximately 20 to 30 seconds). Then, turn the key start switch back to the ON position.You will be asked to select a display software file (.SG1 file) for the upgrade.
Select the file that you had copied to the data card.
Press "OK".A dialog will show the software version 5.01.
Press "OK" in order to confirm the software version.An informational screen will appear.
Press "OK".The CD550 software will begin upgrading. This will take a few minutes.
When prompted, disconnect the external power from the CD550 display. Wait 30 seconds and reconnect the power. The display will turn on automatically.Upgrading the GPS Receiver Firmware
Do not remove power to the system during the GPS receiver upgrade. Removing power during the upgrade may cause a failure of the GPS receiver.
You are again asked to select a display software file for upgrade.
Press "ESC".A message "the application is about to run on the Compact Flash card" will be displayed.
Press "OK".A list box will