TURBOCHARGER GP 2848276 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals for wear or for damage. Replace the components, if necessary.Note: Lubricate O-rings and seals with lubricant used while in operation.
Illustration 1 g03390625
Install two fittings (6) .Note: An O-ring is located on each fitting (6) .
Illustration 2 g03390624
Illustration 3 g03390623
Note: Three O-rings (5) are located on each solenoid (4) .
Install solenoid (4). Fasten two bolts (3) .
Illustration 4 g03390622
Install two O-rings (1) .End By: Install the control manifold.