TURBOCHARGER GP 2W2256 - Caterpillar

Separation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     3    
B     138-7575     Link Bracket     3    Start By:
Remove the transmission and output transfer gears. Refer to Disassembly and Assembly, "Transmission and Output Transfer Gears - Remove".Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be cleaned thoroughly to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01199124
Remove bolt (1) and retainer (2) from yoke (3) .
Remove O-ring seal (4) (not shown) and yoke (3) .
Illustration 2 g01199123
Remove three bolts (5). Remove guard (6) .
Illustration 3 g01199125
Install Tooling (A) and a suitable lifting device to cover (7). The weight of cover (7) is approximately 43 kg (95 lb).
Remove fourteen bolts (8) from cover (7). Remove cover (7) .
Illustration 4 g01199128
Remove two O-ring seals (11) .
Remove seal (9) .
Remove sleeve (10) from cover (7). Remove the O-ring seals from sleeve (10) .
Illustration 5 g01199129
Remove spacer (12) .
Fasten Tooling (B) and a suitable hoist to transmission assembly (13). The weight of the transmission assembly is 544 kg (1200 lb).
Remove bolts (14) that hold transmission assembly (13) to output transfer gears (15) .
Use two 3/8" - 16 NC forcing screws to separate transmission assembly (13) from output transfer gears (15). Remove transmission assembly (13) from output transfer gears (15) .