TURBOCHARGER 3309598 - Caterpillar

1. Remove cover (2) from linkage housing (1). 2. Remove spring (8) and three rings and pins (6). Remove plunger (5) and link (7). Remove ring and two washers (4), then remove lever (3). 3. Remove bearing (9) from the lever. 4. Remove roll pin (10) and remove link (11) from the plunger. 5. Remove O-ring seal (12) from body (13). Remove the body from the housing and remove another seal from the body. 6. Remove plug (14) from the housing. Remove ring and washer (15) from the shaft. 7. Remove the bolt from lever (18) with an allen wrench. Remove shaft (16) and lever (18) from the housing.8. Remove two bearings (17) from the housing. One is larger than the other.Assemble Governor Pedal Group
1. Install two bearings (2) in linkage housing (1) with tooling (A). Install the bearings with the seal toward the outside of the housing and so that the bearings do not extend beyond the outer surface of the housing.2. Loosen the nut on bolt (3) and turn the bolt to get a measurement of 7.11 0.76 (.28 .03 in.) (dimension B) from the end of the bolt to the housing. See illustration in Install Governor Pedal Group. 3. Install shaft (5) and lever (6) in the linkage housing as shown. The lever is to be installed on the shaft. Use an allen wrench to tighten bolt (7) through hole (4). 4. Install washer (9) and ring (10) to hold shaft (5) in place. Install plug (8) in hole (4). 5. Install seal (13) on body (12) and install the body in the linkage housing. Install seal (11) to the body. 6. Connect link (14) to coupler (16) and install roll pin (15). 7. Install bearing (17) in lever (18) with tooling (A). Push on the end with identification only. If pin (22) and dowel (30) were removed, then install them so that the pin is 22.23 mm (.875 in.) above the pin boss. Install the dowel so it is 15.75 mm (.62 in.) above its boss.8. Install coupler assembly (19) in the body with the groove (slot) up. Install washer (21) and lever assembly (20) on pin (22) as shown. 9. Install washer (23) and ring (24) on pin (22). Put the holes in the lever and in the coupler link in alignment, then install pin (26) and ring (25). 10. Install upper link (28) between lever (20) and lever (6), then install two pins (29) and two rings (27). 11. Install spring (31) to lever assembly (20) and dowel (30). 12. Install gasket (33) and cover (32) to the linkage housing. Install seven bolts and lockwashers.