TURBOCHARGER GP 3517450 - Caterpillar

Illustration 1 g01423836
(A) Depth of the two lip type seals in the cylinder assembly ... 1.0 0.5 mm (0.04 0.02 inch) (B) Depth of the two lip type seals in the rod assembly ... 1.0 0.5 mm (0.04 0.02 inch)Note: Lubricate the face and threads of the special locknut (1) with 248-7522 Hydraulic Oil all around before assembly. (1) Torque for the special locknut ... 3600 180 N m (2660 135 lb ft) (2) Lubricate the inside diameter and outside diameter of the three rings with 1P-0808 Multipurpose Grease . (3) Lubricate the inside diameter and outside diameter of the seal with 1P-0808 Multipurpose Grease .Note: During the press fit, insert the sleeve bearing (4) with the tapered side first. (4) 260-2528 Sleeve Bearing Outside diameter ... 85.102 0.011 mm (3.3505 0.0004 inch) Inside diameter ... 70.11 0.02 mm (2.760 0.001 inch) (C) Outside diameter of the new piston over two lands ... 98.90 0.03 mm (3.894 0.001 inch) (D) Bore of new tube in the cylinder assembly ... 100.00 0.10 mm (3.937 0.004 inch) (E) Outside diameter of new rod assembly after plating ... 69.93 0.03 mm (2.753 0.001 inch) (F) Bore of new head over two lands ... 70.530 0.030 mm (2.7768 0.0012 inch) (5) 240-2912 Sleeve Bearing Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.20 0.04 mm (3.157 0.002 inch) (G) Installation depth of sleeve bearing (4) in cap assembly ... 9.85 0.50 mm (0.388 0.020 inch) (H) Installation depth of sleeve bearing (5) in rod assembly ... 10.0 0.5 mm (0.39 0.02 inch) (6) Lightly lubricate the sealing lip of the buffer seal with the lubricant that is being sealed. (7) Lightly lubricate the sealing lip of the U-cup seal with the lubricant that is being sealed. (8) Lightly lubricate the sealing lip of the lip type seal with the lubricant that is being sealed. (9) Apply 4C-4032 Bearing Mount Compound to the wiper seal groove before assembly.