TURBOCHARGER GP 3S4420 - Caterpillar

Event Codes
Logged Event Codes
Illustration 2 g02202815
Typical Cat ET screen for logged events
An indicator for logged events is provided, which allows intermittent event codes to be tracked. The data for a logged event will include the following:
Event Identifier (EID)
Text description of the problem
Number of occurrences of the problem
Time stamp displaying the first occurrence of the problem
Time stamp displaying the last occurrence of the problemCat ET Status Groups
The Status groups are lists of machine parameters shown in real time.
Illustration 3 g02204894
Typical Cat ET status screen
Configure VIMSTM Outputs
Use Cat ET to configure the outputs for VIMSTM.Procedure
Connect a computer with Cat ET to the machine service connector via the communication adapter.
Turn the disconnect key and the keyswitch ON.
Start Cat ET.
Establish communication with the machine.
Illustration 4 g00895412
Select "Service".
Illustration 5 g00895419
Select "Configuration".
Select the "Configuration" option of the "Service" menu or press the "F5" key.The "Configuration" screen will be displayed. See Illustration 6.
Illustration 6 g06197776
Select the parameter.Configure the output diagnostics for the parameters listed in Table 1.
Table 1
Output Parameters of the Product Link Elite ECM
Description Values
Front Axle Strut Pressure to Payload Weight Ratio Configuration XXXX(1)
Empty Machine Wt xxx.xxx(2)
Empty Machine Rear Axle Weight Distribution xx.x(2)
Loaded Machine Rear Axle Weight Distribution xx.x(2)
Machine Tire Weight-Speed Machine Speed Limit xx.x(2)
Machine Weight-Speed Averaging Duration x(2)
Machine Speed Limit Activation Front Tires Weight-Speed Threshold xxxx(2)
Machine Speed Limit Deactivation Front Tires Weight-Speed Threshold xxxx(2)
Machine Speed Limit Activation Rear Tires Weight-Speed Threshold xxxx(2)
Machine Speed Limit Deactivation Rear Tires Weight-Speed Threshold xxxx(2)
Green TPMS Lamp Installation Configuration Installed
Incandescent lamp
LED
Red TPMS Lamp Installation Configuration Installed
Incandescent lamp
LED
Tire Analysis System Installation Status Not Installed
Road Analysis System Installation Status Not Installed
Road Analysis Severity Selection 0
(1) The values for each model are the standard value. Do not adjust the values unless you have authorization.
(2) These values are configurable only if "TKPH" is activated through the attachment code.
Click the "Change" button on the "Configuration" screen. A dialog box will be displayed.
Illustration 7 g01967694
Click the down arrow on the right-hand side of the dialog box.The parameter settings will be displayed.
Highlight the new value.
Click the "OK" button.Cat ET will display the following:
Illustration 8 g01961187
Click the "Yes" button to change the parameter setting or the "No" button to cancel the parameter setting change.