TURBOCHARGER ASSEMBLY 3S4442 - Caterpillar

If the rated output voltage of the generator is greater than 600 volts, the generator and connected load cable capacitances must be discharged prior to servicing the generator.When you service an electric power generation set or when you repair an electric power generation set, follow the procedure below:
Stop the engine.
Illustration 1 g00104545
Attach a "DO NOT OPERATE" or similar warning tag to the engine prime mover starting circuit. Disconnect the engine starting circuit.
Disconnect the generator from the distribution system.
Lock out the circuit breaker. Attach a "DO NOT OPERATE" or similar warning tag to the circuit breaker. Refer to the electrical diagram. Verify that all points of possible reverse power flow have been locked out.
For the following circuitry, remove the transformer's fuses:
Power
Sensing
Control
Attach a "DO NOT OPERATE" or similar warning tag to the generator excitation controls.
Remove the cover of the generator's terminal box.
Use an audio/visual proximity tester in order to verify that the generator is de-energized. This tester must be insulated for the proper voltage rating. Follow all guidelines in order to verify that the tester is operational.
Determine that the generator is in a de-energized condition. Ensure that any power source is in this condition: removed, disabled, locked state, tagged out and tested out. Add ground straps to the conductors or terminals. Connect the ground straps to the electrical distribution system's common grounding location or to the ground system. During the entire work period, these ground straps must remain connected to the conductors and generator terminals.