TURBOCHARGER AS 4662681 - Caterpillar

TARGET="_parent">Backup Alarm - Test
Brakes, Indicators and Gauges - Test
Bulldozer Power Angling Tilt Hinge Pins - Lubricate
Cab Filter (Fresh Air) - Clean/Inspect/Replace
Cooling System Level - Check
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Winch Fairlead Rollers - Lubricate
Every 50 Service Hours or Weekly
Cab Filter (Recirculation) - Clean/Inspect/Replace
Equalizer Bar Center Pin - Lubricate
Front Idler Position - Check/Adjust
Ripper Linkage and Cylinder Bearings - Lubricate
Track Pins - Inspect
Initial 250 Service Hours
Engine Oil and Filter - Change
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 250 Service Hours or Monthly
Belt - Inspect/Replace
Equalizer Bar Pins and Recoil Bearings - Lubricate
Final Drive Oil Level - Check
Final Drive Oil Level - Check
Pivot Shaft Oil Level - Check
Track Roller Frame - Inspect
Winch Oil Level - Check
Initial 500 Service Hours
Engine Valve Lash - Check
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Engine Air Filter Primary Element - Clean/Replace
Engine Air Precleaner - Clean
Final Drive Oil Sample - Obtain
Final Drive Oil Sample - Obtain
Fuel System Primary Filter - Replace
Fuel System Secondary Filter - Replace
Fuel System Third Filter - Replace
Hydraulic System Oil Sample - Obtain
Winch Oil Sample - Obtain
Every 500 Service Hours or 3 Months
Engine Oil and Filter - Change
Fuel Tank Cap Filter and Strainer - Replace/Clean
Every 500 Service Hours or 1 Year
Track - Check/Adjust
Winch Drum Bearing - Lubricate
Every 1000 Service Hours
Engine Valve Lash - Check
Every 1000 Service Hours or 6 Months
Battery - Inspect
Hydraulic System Oil Filter - Replace
Hydraulic System Oil Filter - Replace
Rollover Protective Structure (ROPS) - Inspect
Every 2000 Service Hours or 1 Year
Final Drive Oil - Change
Final Drive Oil - Change
Hydraulic System Oil - Change
Idler Guide Wear Plates - Inspect
Idler Guide Wear Plates - Inspect
Winch Oil - Change
Winch Vent Plug - Clean
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Refrigerant Dryer - Replace
Every 3000 Service Hours or 2 Years
Cooling System Water Temperature Regulator - Clean/Replace
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Cooling System Extended Life Coolant - Change