TURBOCHARGER GP 4W1227 - Caterpillar

Table 1
Service Tools    
Part Number    Part    
JERD2129     Caterpillar® Electronic Technician    
FERV0066     VIMSpc    
317-7484     Communication Adapter Gp    
257-9140     Digital Multimeter    
146-4080 (1)     Digital Multimeter Gp    
8T-3224     Needle Tip    
7X-1710     Multimeter Probe    
8T-8726     Adapter Cable As    
6V-3000     Connector Repair Kit    
190-8900     Connector Repair Kit    
175-3700     Connector Repair Kit    
147-6456     Wedge Removal Tool    
370-4617     Cable As    
185-3996     Thread Lock Compound    
1P-0810     Electrical Tape    
1U-5804     Crimp Tool    
327-8981     Cable As    
5P-7277     Voltage Tester    
7X-1700     Communication Adapter Gp    
8T-0065     Silicone Sealant    
8T-0500     Continuity Test Light    
( 1 ) This multimeter can use an RS232C cable to connect to a laptop computer or Dataview tool gp for troubleshooting.Note: Caterpillar® Electronic Technician (Cat® ET) and VIMSpc are service tools designed to run on a personal computer (PC) under Microsoft WindowsVIMSpc
VIMSpc can access all the VIMSTM information for the machine.VIMSpc is a software tool used to analyze data downloaded from a machine. VIMSpc does not need to connect to a machine. VIMSpc can be used to generate reports that provide historical records of the operating conditions for the machine. The operating conditions represent the work environment as well as the operating parameters of the machine in the work environment. These reports can be used to monitor trends in the work environment and machine operation. Caterpillar® Electronic Technician
Limited VIMS information is available via the Caterpillar® Electronic Technician (Cat® ET).Cat ET is not required to view or clear the diagnostic codes. However, the process of determining the diagnostic codes is easier with Cat ET. Cat ET may also display the history and parameter status of a diagnostic code.Cat ET is used to communicate to the electronic control module (ECM) over the data link by connecting to the machine diagnostic connector. For more information about connectors, see Troubleshooting, "Electrical Components and Connector Locations" and the machine Electrical Schematic.To use Cat ET, the following materials must be ordered:
Special Publication, JERD2124, "ET Single Use Program License"
Special Publication, JEHP1026, "Information and Requirements Sheet"
Special Publication, JERD2142, "Data Subscription"The Special Publication, JEHP1026, "Information and Requirements Sheet" lists the required hardware and the features of Cat ET. For instructions on servicing Sure Seal connectors, see Special Instruction, SMHS7531. For instructions on servicing the Deutsch DT type connectors, see Special Instruction, SEHS9615.Multimeters
Use a calibrated digital multimeter to test continuity and voltage. See the instructions that are provided in the multimeter manual to operate the multimeter safely. The 7X-1710 Multimeter Probes are used to take measurements at a connector without separating the connections. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a three pin breakout and is used for sensor circuit measurements.Note: Use a 8T-0500 Continuity Tester and a 5P-7277 Voltage Tester to test a harness.