TURBOCHARGER GP 5198017 - Caterpillar

Improper lifting and tie-down techniques can allow the load to shift or fail resulting in personal injury or property damage. Use only properly rated cables and slings with lift and tie down points provided on the machine. Keep the deck of the transport vehicle clean and use anti-slip mats on steel decks.Follow the instructions in Operation and Maintenance Manual, "Lifting and Tying Down the Machine" for the proper technique for securing the machine. Refer to Operation and Maintenance Manual, "Specifications" for specific weight information.
Illustration 1 g06289667The lift and tie-down film is located near the base of the boom.Lifting the machine
Illustration 2 g06184026
The machine center of gravity is at the center of the swing gear.
Lifting Point - To lift the machine, attach the lifting devices to the lifting points.The weight and the instructions that are given herein describe the machine as the machine is manufactured by Caterpillar.Refer to the Operation and Maintenance, "Specifications" for specific weight information.Note: Only lift objects from approved lifting points and with approved lifting devices
Use proper rated cables and slings for lifting. The crane should be positioned so that the machine is lifted parallel to the ground.
To prevent contact with the machine, lifting cables should have sufficient length.
Move the hydraulic lockout control to the LOCKED position.
Thread the cable between the first and second rollers at each end of the track.
Do not use the foot step as a lifting point.
Illustration 3 g06279536
If the full length roller guard is equipped, there are holes at the ends of the guard for lifting cables. Refer to Illustration 3.
Apply the proper protector to prevent machine/wire damage and slippage. Make sure that the rollers are not affected by the load.Tying Down the Machine
Note: Obey all local and regional governmental regulations.Diagonal Lashing
Illustration 4 g06320399
(A) Front of the machine
(B) Rear of the machineTying Down the Machine
Tie Down Point - To tie down the machine, attach the tie-downs to the tie-down points.The weight and the instructions that are given herein describe the machine as the machine is manufactured by Caterpillar.Refer to the Operation and Maintenance, "Specifications" for specific weight information.
Use proper rated cables and shackles for tying down the machine.
Use the rear eyes and the front eyes that are provided on the lower frame to fasten tie-downs. Use corner protectors for sharp corners.
Move the hydraulic lockout control to the LOCKED position.
Set the lashing angle, which is on the longitudinal axis of the machine and the cable, at 30 to 50 degrees.
Keep the transport vehicle surface clean (for example, trailer deck).
For steel deck transport vehicles use skid-inhibiting or anti-slip mats (for example, rubber mats) with a friction coefficient of at least 0.3.Lifting the Machine Segments
Bucket
Illustration 5 g06184591
(1) Pin. (2) Sleeve. (3) Bolts. (4) Nuts.
Install pin (1) and install sleeve (2) in the brackets of the bucket. The previous illustration indicates the method to secure pin (1) with bolts (3) and nuts (4). Fasten two proper rated wire cables to pin (1).