TURBOCHARGER GROUP 6N0578 - Caterpillar

Install barrel (27) and spacer (29) on shaft (28).
Illustration 21 g00283199
Install bearing (26) on the shaft.
Position gasket (25) on the housing.
Illustration 22 g00283198
Install race (22).Note: During installation, notch (23) in plate (21) must be aligned with pin (24).
Illustration 23 g00283157
Install gasket (20) and plate (21).
Illustration 24 g00283156
Install housing (18) and bolts (19). The torque for bolts (19) is 33 2 N m (24 15 lb ft).
Illustration 25 g00283155
Install coupling (17).
Illustration 26 g00283154
Install flex plate (16) and the seals.Note: The bronze face of the flex plate must be facing toward the rotor.
Illustration 27 g00283153
Install vanes (15), rotor (14), and ring (13).Note: The vanes must be installed so that the leading edge is facing toward the direction of travel.
Illustration 28 g00283152
Install flex plate (12).Note: The bronze face of the flex plate must be facing toward the rotor.
Illustration 29 g00283151
Turn the plate onto the opposite side and install seals (11).
Illustration 30 g00928727
Install bearing (10) and retaining ring (9).
Install ring seal (9B) and O-ring seal (9A).
Illustration 31 g00283149
Install plate (8) and the shaft.
Illustration 32 g00283147
Install two bolts (7). The torque for bolts (7) is 11 1 N m (97 9 lb in).
Illustration 33 g00283146
Install retaining ring (6) on the shaft.
Illustration 34 g00928725
Install cartridge (5).
Install ring seal (5B) and O-ring seal (5A).
Illustration 35 g00283144
Install cover (2), coupling (3), O-ring seal (4), and bolts (1).End By:
Install the hydraulic pump. Refer to Disassembly and Assembly, "Piston and Vane Pump (Steering and Implement) - Install"
.