TURBOCHARGER GP 7E0473 - Caterpillar

Installation Procedure
Illustration 1 g03863426
View of left-hand side film installation
(1) 349-8604 Film
(2) 421-0178 Door As
(3) 349-8603 Film
Select either film (1) or film (3) per ANSI or ISO regulations that applies to your machine. (Should match film that is currently in place above door). Install film onto door assembly (2) as shown in Illustration 1.
Illustration 2 g06211102
View of right-hand side film installation
(2) 421-0177 Door As
(4) 344-5036 Film
(5) 345-4619 Film
Install film (4) and film (5) onto door assembly (2).
Install latch assembly (7) onto door assemblies (2).
Remove lock washer (8) and nut (9) from latch assembly (7).
Illustration 3 g06211103
View of latch installation
(2) 421-0178 Door As
(7) 275-0572 Latch As
(8) Washer
(9) Nut
Install latch assembly (7) to door assemblies (2) making sure that latch is positioned vertical long ways. Secure using washer (8) and nut (9).Torque nut (9) to 15 1 N m (11 1 lb ft).
Illustration 4 g03863483
View of cam-lock installation
(7) 275-0572 Latch As
(10) 461-5429 Latch Cam
(11) Hex bolt
Install cam (10) to latch assembly (7) using bolt (11). Insure cam (10) in vertical when installed in locked position to match latch assembly (7). Torque bolt (11) to 6 0.5 N m (53 4 lb in).
Illustration 5 g06211114
View of door assembly and plate installation
(A) Existing hardware
(2) 421-0178 Door As
(12) 3E-8020 Screw
Illustration 6 g03873648
View of bumper
(13) 281-3974 Bumper
When installing door assemblies (2), on the rear of the machine. Start by removing existing hardware (A). Install door assemblies (2) using screws (12). On left-hand door assembly (2), install bumpers (13) closest to the rear door.Note: If door assembly will not open when bumper (13) is installed, only install bumper on the top of door assembly (2).