U JOINT KIT 0316117 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the engine oil. Refer to the Operation and Maintenance Manual, "Refill Capacities and Recommendation" for the capacity of the lubrication system.
Illustration 1 g01034801
Remove drain plug (1) . Remove bolts (3) and pan assembly (2) from cylinder block (4) .
Illustration 2 g01034802
Remove bolts (7) . Remove oil strainer (5) and O-ring seal (6) .Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     Loctite 5900     -    
B     -     Loctite 243     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean all mating surfaces thoroughly.
Illustration 3 g01034802
Position O-ring seal (6) and oil strainer (5) . Install bolts (7) .
Illustration 4 g01034801
Apply Tooling (A) to cylinder block (4) on the inside of the bolt hole pattern.Note: Apply Tooling (A) in a continuous bead in order to help prevent an oil leak.
Position pan assembly (2) on the cylinder block. Apply Tooling (B) to bolts (3) . Install bolts (3) and tighten to a torque of 10 to 13 N m (7 to 10 lb ft). Install drain plug (1) and tighten to a torque of 34 to 44 N m (25 to 32 lb ft).
Fill the crankcase with engine oil. Refer to the Operation and Maintenance Manual, "Refill Capacities and Recommendations" for the capacity of the lubrication system.