UNIVERSAL JOINT GP 1082109 - Caterpillar

- The value is selectable from 0 to 250 seconds in increments of 1 second. The default setting from the factory is 0 seconds. SP09 Spare Input 2 Delay Time - The value is selectable from 0 to 250 seconds in increments of 1 second. The default setting from the factory is 0 seconds.SP10 Spare Input 3 Delay Time - The value is selectable from 0 to 250 seconds in increments of one second. The default setting from the factory is 0 seconds.Alarm Mode Sequence Of Operation - When a fault occurs in a spare input and the fault is programmed as an alarm fault, the GSC will respond in the following manner:
The GSC waits for the programmed time delay.
The fault alarm indicator FLASHES.
When the alarm codes key is pressed, the corresponding SP fault code is shown on the upper display of the GSC.
The engine continues to run or the engine is able to start.Shutdown Mode Sequence Of Operation - When a fault occurs in a spare input and the fault is programmed as a shutdown fault, the GSC will respond in the following manner:
The GSC waits for the programmed time delay.
The fault shutdown indicator FLASHES.
The corresponding SP fault code of SP1, SP2, or SP3 is immediately shown on the upper display of the GSC.
The engine is shut down or the engine is disabled from starting.The fault shutdown indicator remains FLASHING and the SP fault code remains shown until the ECS is turned to OFF/RESET. After you turn the ECS to OFF/RESET and after you correct the cause of the spare fault, the engine is able to start and the engine is able to run. Note: SP fault codes are not logged into the GSC fault log. Note: If the operator does not desire the use of the spare inputs, then program the spare inputs for a LOW active state and connect nothing to the spare input wiring.Spare Output
Note: The spare output is usually used to give a high logic signal to a device for a customer or the spare output is used to give a low logic signal to a device for a customer. However, the spare output can be programmed to be a spare data output on the latest generator set controls. As a spare data output, the necessary serial data is available for operating the optional relay driver module (RDM). Earlier generator set controls such as the 133-6350123-6004136-3870 EMCP Electronic Controls do not have the serial data capability which is necessary for the RDM. The spare output responds to a selected trigger condition. The response and the trigger condition are programmable. The spare output is accessed on the auxiliary terminal strip (AUX) within the control panel on the left wall. The spare output is marked as "SPARE" on the auxiliary terminal strip.
Illustration 3 g00307942
Typical Active Low Configuration For Spare Output
Illustration 4 g00308023
Typical Active High Configuration For Spare OutputThe GSC must be programmed to make the active state of the spare output high or low. An active low