UNIVERSAL JOINT GP 1666758 - Caterpillar

Remove Camshaft Bearings
Start By:a. remove camshaftb. remove flywheel housingc. remove pistons 1. Remove the rear camshaft bearing with Tool (A).2. Remove the remainder of the camshaft bearings with Tool (A). Start at the rear of the engine block and move toward the front.Install Camshaft Bearings
1. Install the rear camshaft bearing and three internal camshaft bearings with Tool (A). Install the bearings from the rear of the block bore. Install the bearings until the front edge of the bearing is even with the front surface (1) of the block bore.
90 15 degreesfrom the oil hole in the block bore.
2. Install the front camshaft bearing with Tool (A) until it is 7.34 0.10 mm (.289 .004 in)from the machined surface on the front of the cylinder block as shown.End By:a. install pistonsb. install flywheel housingc. install camshaft