UNIVERSAL JOINT GP 1846767 - Caterpillar

Remove bolt (17) and retainer (16) from the shaft. Remove the pin from retainer (16) .
Illustration 12 g00700499
Illustration 13 g00700501
Race (20) will be removed from the shaft when impeller (19) is separated from housing (15). If necessary, heat race (20) in order to make the separation of the impeller and the housing easier. If the race is heated, the race may be damaged. Then, you must replace the race.
Remove bolts (18) that hold wheel (19) to housing (15) .
Install two 3/8 inch - 16 NC forcing screws in impeller (19). Tighten the forcing screws evenly in order to separate the impeller from housing (15) .
Remove race (20) from the shaft.
Illustration 14 g00700503
Remove bearing (21) from housing (15) .
Illustration 15 g00700504
It may be necessary to heat race (24) in order to remove the race from shaft (23). If the race is heated, the race may be damaged. Then, you must replace the race.
If necessary, heat race (24). Then remove the race from shaft (23) .
Remove turbine (22) from shaft (23) .
Illustration 16 g00700506
Remove ring (28) from the shaft by using Tooling (B) .
Remove the following parts from the shaft: six bolts (25), two plates (27) and stator (26) .
Illustration 17 g00700508
Remove the following parts from the shaft: six bolts (30), two plates (29) and impeller (19) .
Illustration 18 g00700510
Remove gear assembly (31) from carrier (32) .
Illustration 19 g00700512
Remove bearing (33) from gear assembly (31) .
Illustration 20 g00700513
Remove ring (34) that holds shaft (23) and the bearing in place in carrier (32) .
Illustration 21 g00700517
Remove shaft (23) and the bearing from carrier (32) by using a press.
Illustration 22 g00700522
Remove pins (35) and sleeve (36) from carrier (32), if necessary.
Illustration 23 g00700525
Remove bearing (37) and ring (38) from shaft (23) .