UNIVERSAL JOINT ASSEMBLY 2M5001 - Caterpillar

2M5001 UNIVERSAL JOINT ASSEMBLY Caterpillar parts 561B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2M5001
2M-5001
2M5001

Caterpillar 2M5001 UNIVERSAL JOINT ASSEMBLY

Weight: 19 pounds 8 kg.

Buy UNIVERSAL JOINT ASSEMBLY 2M5001 Caterpillar genuine, new aftermarket tractor parts with delivery
PIPELAYER,

This part in 1 request: Show. This information for suppliers only!

#197957 2M5001

2018-08-13

Compatible equipment models: 2M5001:

PIPELAYER 561B Caterpillar

Number on catalog scheme: None

Caterpillar 2M5001 Parts scheme UNIVERSAL JOINT ASSEMBLY

For full view, you need register

Information:

Table 1
Diagnostic Codes Table
Code and Description Conditions which Generate this Code System Response Procedure
253-2 Personality Module erratic, intermittent, or incorrect The flash file is for a different engine family or for a different engine application. The engine will not start. Clearing this diagnostic code requires factory passwords. The personality module code must be reset to zero. Program the correct flash file. Replacing the Personality Module
The personality module is the software which controls the behavior of the Electronic Control Module (ECM). The personality module contains all of the software for the ECM. When troubleshooting has indicated that the personality module has failed, temporarily mount a new personality module on the side of the engine. Test the engine with the new personality module. If the problem no longer exists, proceed with the following steps.Note: Updating the personality module to a different version may cause some engine functions to behave in a different manner.
Illustration 1 g01622820
Remove the personality module access cover.
Firmly grasp the clips on the old personality module and detach the module from the ECM.
Install the new personality module into the ECM. Make sure that the personality module seats properly into the socket of the ECM.Note: The personality module will only match the keyed socket in one position. A click can be felt when the module is pushed in correctly.
Install the personality module cover. The O-Ring must be seated properly.Note: Improper installation of the O-Ring could result in damage to the module from improper sealing. This will allow moisture to enter the socket.
Start the engine and check for proper operation.Note: Customer parameters and system parameters must be programmed on the initial installation of a new ECM. Program the parameters into the ECM when the ECM is initially energized. Refer to Troubleshooting, "ECM/Personality Module - Test" for troubleshooting procedures.