UNIVERSAL JOINT GP 3978043 - Caterpillar

Install race (20) on shaft (1) .
Illustration 14 g00700746
Put the torque converter assembly in position in housing (22). Install bolts (21). Tighten the bolts to a torque of 30 5 N m (22 4 lb ft).
Illustration 15 g00700748
Install bearing (23) in housing (22) .
Install race (24) on the shaft.
Illustration 16 g00700750
Install the pin in retainer (25). Put the retainer in position on the end of the shaft. Install bolt (26). Tighten the bolt to a torque of 120 15 N m (90 11 lb ft).
Illustration 17 g00700752
Put retainer (27) in position on the housing. Install bolts (28). Tighten the bolts to a torque of 50 7 N m (37 5 lb ft).
Illustration 18 g00700754
Put O-ring seals (29) in position on carrier (6) .
Illustration 19 g00700755
Install seal (30) in the torque converter housing by using Tooling (D). Install the seal so that the lip is down, as shown. Put clean oil on the lip of the seal.
Illustration 20 g00700756
Install two 3/8 inch - 16 NC x 101.6 mm (4 inch) guide bolts (31) in the carrier.
Fasten a hoist and two 3/8 inch - 16 NC forged eyebolts to torque converter housing (32) .
Put the torque converter housing in position on the torque converter. Install the bolts that hold the torque converter in place. Tighten the bolts to a torque of 50 3 N m (37 2 lb ft).
Illustration 21 g00700758
If plug (34) was removed, install the plug on gear (33). Make sure that the end of the plug is 1.25 0.25 mm (0.049 0.010 inch) below the surface of the gear.
Illustration 22 g00700759
If bearing (35) was removed, heat the bearing to a maximum temperature of 135 °C (275 °F). Install the bearing on gear (33) .
Illustration 23 g00700763
Install two bearing cups (37) and the spacer in adapter (36) .
Install O-ring seal (38) on adapter (36). Put clean oil on the O-ring seal.
Illustration 24 g00700766
Put adapter (36) in position on gear (33) .
Heat bearing (39) to a maximum temperature of 135 °C (275 °F). Install the bearing in gear (33) .
Put washer (40) in position. Install snap ring (41) by using Tooling (E) .
Illustration 25 g00700767
Put adapters (36) in position on the torque converter housing. Install the bolts that hold the adapters in place.
Put the following parts on the torque converter output shaft: yoke, O-ring seal and washer. Install the bolt that holds the parts in place. Tighten the bolt to a torque of 110 5 N m (80 4 lb ft).End By:
Install the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Torque Converter Outlet Relief Valve - Install" for the machine that is being serviced.
Install the torque converter. Refer to Disassembly and Assembly, "Torque Converter - Install" for the machine that is being serviced.