3W2388 UNIVERSAL JOINT GP Caterpillar parts
D5H
Rating:
Alternative (cross code) number:
CA3W2388
3W-2388
3W2388
CA3W2388
3W-2388
3W2388
Weight: 14 pounds 6 kg.
TRACK-TYPE TRACTOR,
Compatible equipment models: 3W2388:
Number on catalog scheme:
2
For full view, you need register
Information:
Fuel Tanks
Condensation can form in partially filled fuel tanks. Top off the fuel tanks after you operate the engine.Fuel tanks should contain some provision for draining water and sediment from the bottom of the tanks. Some fuel tanks use supply pipes that allow water and sediment to settle below the end of the fuel supply pipe.Some fuel tanks use supply lines that take fuel directly from the bottom of the tank. If the engine is equipped with this system, regular maintenance of the fuel system filter is important.Drain the water and sediment from any fuel storage tank at the following intervals: weekly, oil changes and refueling of the fuel tank. This will help prevent water and/or sediment from being pumped from the fuel storage tank and into the engine fuel tank.Fuel Filters
It is possible that a primary fuel filter is installed between the fuel tank and the engine fuel inlet. After you change the fuel filter, always prime the fuel system in order to remove air bubbles from the fuel system. Refer to the Operation and Maintenance Manual in the Maintenance Section for more information on priming the fuel system.The micron rating and the location of a primary fuel filter is important in cold weather operation. The primary fuel filter and the fuel supply line are the most common components that are affected by cold fuel.Fuel Heaters
Fuel heaters help to prevent fuel filters from plugging in cold weather due to waxing. A fuel heater should be installed in the fuel system before the primary fuel filter.The following fuel heaters are recommended for Caterpillar engines:
7C-3557 Fuel Heater Group
7C-3558 Heater KitFor further information on fuel heaters, consult your Caterpillar dealer.Disconnect the fuel heater in warm weather.Note: Fuel heaters that are controlled by the water temperature regulator or self-regulating fuel heaters should be used with this engine. Fuel heaters that are not controlled by the water temperature regulator can heat the fuel in excess of 65°C (149°F). A loss of engine power can occur if the fuel supply temperature exceeds 37°C (100°F).Note: Heat exchanger type fuel heaters should have a bypass provision in order to prevent overheating of the fuel in warm weather operation.
Condensation can form in partially filled fuel tanks. Top off the fuel tanks after you operate the engine.Fuel tanks should contain some provision for draining water and sediment from the bottom of the tanks. Some fuel tanks use supply pipes that allow water and sediment to settle below the end of the fuel supply pipe.Some fuel tanks use supply lines that take fuel directly from the bottom of the tank. If the engine is equipped with this system, regular maintenance of the fuel system filter is important.Drain the water and sediment from any fuel storage tank at the following intervals: weekly, oil changes and refueling of the fuel tank. This will help prevent water and/or sediment from being pumped from the fuel storage tank and into the engine fuel tank.Fuel Filters
It is possible that a primary fuel filter is installed between the fuel tank and the engine fuel inlet. After you change the fuel filter, always prime the fuel system in order to remove air bubbles from the fuel system. Refer to the Operation and Maintenance Manual in the Maintenance Section for more information on priming the fuel system.The micron rating and the location of a primary fuel filter is important in cold weather operation. The primary fuel filter and the fuel supply line are the most common components that are affected by cold fuel.Fuel Heaters
Fuel heaters help to prevent fuel filters from plugging in cold weather due to waxing. A fuel heater should be installed in the fuel system before the primary fuel filter.The following fuel heaters are recommended for Caterpillar engines:
7C-3557 Fuel Heater Group
7C-3558 Heater KitFor further information on fuel heaters, consult your Caterpillar dealer.Disconnect the fuel heater in warm weather.Note: Fuel heaters that are controlled by the water temperature regulator or self-regulating fuel heaters should be used with this engine. Fuel heaters that are not controlled by the water temperature regulator can heat the fuel in excess of 65°C (149°F). A loss of engine power can occur if the fuel supply temperature exceeds 37°C (100°F).Note: Heat exchanger type fuel heaters should have a bypass provision in order to prevent overheating of the fuel in warm weather operation.
Caterpillar SIS machinery equipment:
Caterpillar SIS
D5H & D5H LGP TRACTORS / DIRECT DRIVE / 7NC00001-03999 (MACHINE) POWERED BY 3304 ENGINE »
3W-2388
UNIVERSAL JOINT GP
D5H & D5H LGP SERIES II TRACTORS - DIRECT DRIVE 7NC04000-UP (MACHINE) POWERED BY 3304 ENGINE »
3W-2388
UNIVERSAL JOINT GP
D5H & D5H LGP SERIES II TRACTORS / DIRECT DRIVE / 1YD04027-UP (MACHINE) POWERED BY 3304 ENGINE »
3W-2388
UNIVERSAL JOINT GP
D5H SERIES II TRACTORS /DIRECT DRIVE/ 1YD05522-UP (MACHINE) POWERED BY 3304 ENGINE »
3W-2388
UNIVERSAL JOINT GROUP
D5H & D5H LGP TRACTORS / DIRECT DRIVE / 1YD00001-UP (MACHINE) POWERED BY 3304 ENGINE »
3W-2388
UNIVERSAL JOINT GP
Caterpillar parts catalog:
Parts universal Caterpillar catalog:
1667202
UNIVERSAL JOINT GP
D350E, D350E II, D400E, D400E II
D350E, D350E II, D400E, D400E II
8V6949
UNIVERSAL JOINT GP
916, G916, IT18
916, G916, IT18
1198303
UNIVERSAL JOINT GP
D250E, D250E II, D300E, D300E II
D250E, D250E II, D300E, D300E II
4H8461
UNIVERSAL JOINT ASSEMBLY
768B, 769, 824, 824B, 825B, 826B
768B, 769, 824, 824B, 825B, 826B
5U0181
UNIVERSAL JOINT GP
D350E, D35HP, D400, D400E, D40D
D350E, D35HP, D400, D400E, D40D
8V6428
UNIVERSAL JOINT GP
936, G936
936, G936
R1600, R1600G, R1600H
936, G936
