V-BELT 0362176 - Caterpillar

Hydraulic Oil Temperature (29) - The hydraulic oil temperature gauge indicates the temperature of the hydraulic oil. If the gauge reaches the red area, the gauge indicates that the temperature is too high. The gauge reaches the red area at 102 °C (215 °F). Digital Display Window (Upper)
Illustration 8 g01037467
Display window (3) provides an information area that shows the following items:
Digital tachometer
Gear indicator
Indication of engine overspeedThe digital tachometer and the gear indicator are displayed continuously. An engine speed that is greater than 2800 rpm will activate an indication of engine overspeed.The gear indicator displays the gear (1, 2, or 3) that has been selected and the direction of travel. An "F" is displayed for FORWARD. An "R" is displayed for REVERSE. An "N" is displayed for NEUTRAL. The engine start switch must be in the ON position in order to activate the display.The tachometer flashes as an indication of engine overspeed. The highest engine speed that is greater than 2800 rpm will stick in the display window for thirty seconds.
Illustration 9 g01046175
When the engine drops below 2600 rpm, you may press operator switch (30) in order to stop the display from flashing before the thirty second timer expires.Note: Refer to Operation and Maintenance Manual, "Engine Overspeed".Digital Display Window (Lower)
Illustration 10 g01046167
Display window (5) provides an information area that can be changed to three different display modes.
Service meter mode
Travel distance mode
Service code modePress switch (30) briefly in order to change the display mode.Service Meter Mode
Illustration 11 g01046172
The service meter mode displays an hourglass symbol (31). This mode indicates the total operating hours of the engine. Use the display in order to determine the maintenance intervals. When the engine start switch is turned to the OFF position, the display defaults back to the service meter mode.The "SERV CODE" indicator (32) will be displayed in the display window when there is an active service code. An action indicator will be flashing. See "Service Code Mode" in this article.Travel Distance Mode
The travel distance mode displays the distance of travel in reverse and in forward, and the total distance of travel. These values are displayed in display window (5) .The travel distance mode will continuously scroll through the above five displays in the following sequence:
reverse direction
miles of travel in reverse gears
forward direction
miles of travel in forward gears
total miles of travelNote: Your Caterpillar dealer can set the units of travel to miles or to kilometers.The "SERV CODE" indicator will be displayed in the display window when there is an active service code. An action indicator will be flashing. See "Service Code Mode" in this article.Service Code Mode
The service code mode displays codes that are used by service technicians in order to diagnose problems of machine systems. Service codes are generated when system faults occur.Each service code consists of three parts:
Module identifier (MID)
Component identifier (CID)
Failure mode identifier (FMI)A module identifier (MID) is a code that identifies the electronic control module that has diagnosed a fault.A component identifier (CID) is a code that informs the service personnel of specific component