V-BELT 0948991 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A         OTC Model 1750A Transmission Jack     1    
Illustration 1 g00700410
Fasten torque converter (10) to Tooling (A). Then position the torque converter underneath the machine.
Illustration 2 g00700412
Install two 3/8 inch - 16 NC guide bolts (11) in the flywheel housing.
Make sure that the O-ring seal is in position on the torque converter housing.
Put the torque converter in position on the flywheel housing. Then position the torque converter on the flywheel housing and install the bolts that hold the torque converter in place.
Remove Tooling (A) .
Illustration 3 g00700368
Install bolts (7) .
Illustration 4 g00700363
Put clamps (6) in position. Then install the bolts that hold the clamps in place.
Illustration 5 g00700360
Connect hoses (3), (4), and (5) .
Illustration 6 g00700357
Put bracket (1) in position. Then install the bolt that holds the bracket in place.
Connect two wire harnesses (2). Put the wire harnesses in position in the clips.End By:
Install the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Torque Converter Outlet Relief Valve - Install" for the machine that is being serviced.
Install the power train oil pump. Refer to Disassembly and Assembly, "Power Train Oil Pump - Install" for the machine that is being serviced.
Install the implement pump. Refer to Disassembly and Assembly, "Machine Systems-Implement Pump - Install" for the machine that is being serviced.
Install the drive shaft. Refer to Disassembly and Assembly, "Main Drive Shaft - Remove and Install" for the machine that is being serviced.