V-BELT 1623492 - Caterpillar

1623492 V-BELT Caterpillar parts 321B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1623492
162-3492
1623492

Weight: 0.27 pounds 0 kg.

Buy V-BELT 1623492 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 1623492:

EXCAVATOR 321B Caterpillar

Number on catalog scheme: 3

For full view, you need register

Information:

Two-Way Flow
Clockwise Rotation (4) - Push this thumb wheel forward in order to rotate the work tool clockwise.
Counterclockwise Rotation (4) - Push this thumb wheel backward in order to rotate the work tool counterclockwise.
Close (5) - Push this thumb wheel forward in order to close the work tool.
Open (5) - Push this thumb wheel rearward in order to open the work tool. Front Shovel
Illustration 4 g00559405
Stick Out (1) - Move the joystick to this position in order to move the stick outward.
Swing Right (2) - Move the joystick to this position in order to swing the upper structure to the right.
Stick In (3) - Move the joystick to this position in order to move the stick inward.
Swing Left (4) - Move the joystick to this position in order to swing the upper structure to the left.
Boom Lower (5) - Move the joystick to this position in order to lower the boom.
Bucket Dump (6) - Move the joystick to this position in order to dump the bucket.
Boom Raise (7) - Move the joystick to this position in order to raise the boom.
Bucket Close (8) - Move the joystick to this position in order to close the bucket. Hold (9) - When you release the joysticks from any position, the joysticks will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a joystick diagonally.In order to change the joystick control pattern, refer to Operation and Maintenance Manual, "Joystick Controls Alternate Patterns".Work Tool Control
Joystick controls have different functions in one-way flow and in two-way flow. One-way flow is used when you operate work tools such as hammers. Two-way flow is used when you operate work tools such as shears, grapples, and pulverizers. In order to switch the hydraulic system between one-way flow and two-way flow, refer to Operation and Maintenance Manual, "Work Tool Flow Mode Control".
Illustration 5 g01132327
Note: Not all switches will have a function in each configuration.
Horn (2) - Press this switch in order to activate the horn.
Open (4) and (5) - Push this thumb wheel forward in order to open the work tool.
Close (4) and (5) - Push this thumb wheel backward in order to close the work tool.
AEC (7) - Press this switch in order to activate low engine speed. Press the switch again in order to activate high engine speed.