V-BELT 1919025 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7574 Link Bracket 2
B 209-8351 Bracket 2 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01021567
Illustration 2 g00996794
Attach Tooling (A) to transmission (14). Install transmission (14). Position transmission (14) in the flywheel housing. The weight of transmission (14) is approximately 1043 kg (2300 lb). Install transmission (14) completely in the flywheel housing.
Install bolts (15). Install mount assembly (16) on both sides of the machine. Remove Tooling (B).
Illustration 3 g01021565
Connect hose (10). Connect hose assembly (11). Connect hose (13). tighten clamp (12).
Illustration 4 g01021564
Connect hose assemblies (8) and (9). Install bolts (6) and (7).
Illustration 5 g00996788
Connect hose assembly (4).
Illustration 6 g00996787
Install guard (3).
Illustration 7 g00996785
Install bolt (2). Connect harness assemblies (1). End By:
Install the drive shaft. Refer to Disassembly and Assembly, "Drive Shaft - Remove and Install".
Install the rear chassis support. Refer to Disassembly and Assembly, "Crankcase Guard - Install".
Install the radiator guard and support. Refer to Disassembly and Assembly, "Radiator Guard and Support, Aftercooler, and Radiator - Install".