V BELT 1N4090 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01248565
Open left door (1) .
Illustration 2 g01248566
Disconnect harness assembly (5) and tube assembly (4). Remove bolts (3) and valve assembly (2) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01248566
Install valve assembly (2) and bolts (3). Connect tube assembly (4) and harness assembly (5) .
Illustration 4 g01248565
Close left door (1) .