V-BELT 2208129 - Caterpillar

Illustration 7 g06166807
Loosen clamp (5), and move hose (7), and hose (6) toward the rear of the machine.
Illustration 8 g06166784
(6) Hose
(7) Hose
(8) Hose
(9) 6V-9831 Cap As
(10) 517-4752 Hose As
(11) 148-8357 Elbow As
(12) 9X-6579 Orifice Nut
(13) 150-3071 Reducer As
(14) 148-8429 Tee As
(15) 148-8357 Elbow As
(16) 521-1039 Thermal Bypass Valve
(17) 260-9189 Swivel Elbow Assembly
(18) 148-8429 Adapter As
(19) 480-3014 Adapter As
Illustration 9 g06168227
Orientation of 148-8357 Elbow As with 521-1039 Thermal Bypass Valve is 45°. (Side view)
Install elbow (15) onto thermal bypass valve (16). Offset the elbow from the valve by 45 degrees as shown in Illustration .
Illustration 10 g06168249
Orientation of 260-9189 Swivel Elbow Assembly is 22° (Top view)
Install swivel elbow (17) onto thermal bypass valve (16). Offset the swivel elbow from the valve by 22 degrees as shown in Illustration
Illustration 11 g06165848
Alignment of 148-8357 Elbow As (Bottom view)
Install elbow (11) onto thermal bypass valve (16). Offset the elbow from the valve by 18 degrees as shown in Illustration .
Install tee (18) onto swivel elbow (17). Connect the top of the tee to the bottom tube at the left of the radiator. Connect hose (7) to the bottom of the tee.
Connect hose (10) to elbow (11). Connect the other end of the hose to top tube at the left of the radiator. Install cap (9) to cap the open port on the top tube.
Connect tee (14) to elbow (15). Connect hose (6) to the bottom port on the tee.
Install Adapter (19) to the remaining port on the tee. Install orifice nut (12) and reducer (13) to Adapter (19). Connect hose (8) to the reducer (13).
Illustration 12 g06166807
Ensure that hoses (6) and (7) are properly positioned. Tighten clamp (5).
Fill the hydraulic tank. Refer to the Operation and Maintenance Manual topic referenced above for instructions.
Illustration 13 g06165783
Assemble sheet (4) and the bulk seal to the machine.
Illustration 14 g06165774
(1) 8T-4189 Bolt
(2) 5P-4116 Hard Washer
(3) 8T-4908 Bolt
Assemble bolt (1) and washer (2) in three places. Assemble bolt (3) and washer (2) in two places.
Illustration 15 g06165863
(19) Radiator enclosure
(TT) 10 + 5 - 3mm (0.4 + 0.2 - 0.12 inch)
(UU) 10 3 mm (0.4 0.12 inch)
Illustration 16 g06167247
Cab side gap dimension 12 2 mm (0.47 0.08 inch)
Correctly align radiator enclosure (19) with the gap dimensions shown in Illustrations.
Close the engine compartment door and enclosure.Reference Section
Special Publication, NENG2500, "Dealer Service Tool Catalog"