V-BELT 2412894 - Caterpillar

Table 2
Pressure Change for One Spacer (1)    
Description     Thickness     Pressure Change     Part    
5M-9623 Spacer    
0.91 mm (.036 inch)    
18.2 kPa (2.64 psi)     Output Relief Valve (11)    
5M-9624 Spacer    
0.25 mm (.010 inch)    
5.0 kPa (.73 psi)    
( 1 ) Before an adjustment is made to outlet relief valve (11) , make sure that the valve springs are not weak or broken.
Table 3
Required Tools    
Part Number     Description     Quantity    
1U-5481     Pressure Gauge Group     1    
1U-5482     Pressure Adapter Group     1    Lockup Clutch Disengaged (Minimum clutch pressure)
The drive shaft rotates between the torque converter and the transmission whenever the engine is running. Contact with the rotating shaft can result in personal injury or death.The rotating shaft is located under the implement and steering pumps. Do not allow personnel into the pump bay area behind the cab when the engine is running.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before moving the machine to perform the test that follows.
Install a hose and a 4130 kPa (600 psi) pressure gauge on pressure tap (C) .
Engage the parking brake and shift the transmission to neutral. Start the engine and run the engine at high idle.
Observe the pressure gauge. The pressure reading on the gauge must be 170 kPa (25 psi) or less.Lockup Clutch Engaged (Maximum stabilized pressure)
The drive shaft rotates between the torque converter and the transmission whenever the engine is running. Contact with the rotating shaft can result in personal injury or death.The rotating shaft is located under the implement and steering pumps. Do not allow personnel into the pump bay area behind the cab when the engine is running.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before moving the machine to perform the test that follows.
Install a hose and a 4130 kPa (600 psi) pressure gauge on pressure tap (C) .
Remove the steering frame lock.
Remove blocks from the wheels.
Move the on/off switch for the torque converter lockup clutch (if equipped) to the ON position.
Engage the parking brake and place the transmission in neutral. Start the engine.
Apply the service brakes and release the parking brake. Place the 992K Wheel Loader in second speed forward. Place the 854K Wheel Tractor in second speed forward.
Operate the machine at maximum speed and observe the pressure reading on the gauge. Make sure that the left service brake pedal or the right service brake pedal are not depressed. If the left service brake pedal or the right service brake pedal are depressed, the lockup