V-BELT SET 2441249 - Caterpillar

Start By:
Remove the work tool positioner. Refer to Disassembly and Assembly, "Work Tool Positioner Control - Remove".
Illustration 1 g00342992
Place Tooling (A) under bucket tilt link (1). This will help to prevent the bucket tilt link from falling when the pin is removed.
Illustration 2 g00349492
Remove bolt (2), the washer, and the spacer from pin assembly (3) .
Illustration 3 g00349532
Attach Tooling (B) and a suitable lifting device to pin assembly (3). Attach a suitable lifting device to the rod end of the tilt cylinder.
Use Tooling (B) in order to remove pin (3). Start the engine and retract the tilt cylinder. Lower the rod end of the tilt cylinder onto the lift arm assembly.
Illustration 4 g00349592
Typical Example
Attach a suitable lifting device to tilt lever (4), as shown. The weight of tilt lever (4) is approximately 255 kg (560 lb).
Illustration 5 g00349593
Remove bolt (5), the washer, and the spacer from pin assembly (6) .
Illustration 6 g00349595
Attach Tooling (C) to pin (6). Use a suitable lifting device in order to support Tooling (C), as shown. Use Tooling (C) in order to remove pin (6) .
Illustration 7 g00349652
Remove bolt (7), the washer, and the spacer from pin assembly (8) .
Illustration 8 g00395883
Attach Tooling (D) and a suitable lifting device to pin assembly (8). Use Tooling (D) in order to remove pin (8). Remove tilt lever (4).
Illustration 9 g00349673
Remove lip seal (9) from the center bore of tilt lever (4). Repeat this step for the opposite side of the tilt lever.
Illustration 10 g00349675
Use Tooling (E) in order to remove the bearing from the tilt lever.