V-BELT 2487475 - Caterpillar

Removal Procedure
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure- Release". Note: Put identification marks on all hose assemblies for installation purposes. Plug all of the hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Clean the swing motor, and clean the area around the swing motor prior to removing the swing motor.
Illustration 1 g01436954
Remove hose assemblies (2). Disconnect hose assemblies (1) from the main control valve in order to provide access for removing the swing motor.
Illustration 2 g01436957
Disconnect hose assemblies (3), (4), (5), (6), and (7) from the swing motor.
Drain the lubricant from the swing drive into a container suitable for storage or for disposal. Refer to Operation and Maintenance, "Swing Drive Oil Level - Change".
Illustration 3 g01436958
Attach a suitable lifting device to swing motor (8). The weight of swing motor (8) is approximately 34 kg (75 lb). Remove bolts (9) that fasten the swing motor to the swing drive. Remove swing motor (8).