V-BELT GP 2P4230 - Caterpillar

Remove & Install Marine Gear Oil Cooler Core
FLUID SPILLAGE CONTAINMENTCare must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "TOOLS AND SHOP PRODUCT GUIDE, NENG2500", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates.1. Drain the coolant from the engine into a suitable container for storage or disposal.2. Disconnect the oil inlet and outlet lines. Cap or plug all openings immediately. 3. Remove eight bolts (1) and cover (2) from the housing, and remove the two O-ring seals from the cover. 4. Remove core assembly (3) and gasket (4) from the housing. The following steps are for installation of the marine gear oil cooler core.5. Put gasket (4) and core assembly (3) in position in the housing.6. Install the two O-ring seals in cover (2). Put cover (2) in position on the housing, and install bolts (1).7. Connect the oil inlet and outlet lines.8. Fill the cooling system with coolant to the correct level. See the Operation & Maintenance Manual.Remove & Install Marine Gear Oil Cooler
FLUID SPILLAGE CONTAINMENTCare must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "TOOLS AND SHOP PRODUCT GUIDE, NENG2500", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates.1. Drain the coolant from the engine into a suitable container for storage or disposal.2. Disconnect the oil inlet and outlet lines. Cap or plug all openings immediately. 3. Disconnect tube (1) from the turbocharger and marine gear oil cooler, and remove the tube. Cap or plug all openings immediately. 4. Remove the bolts that hold clip (4) to the oil cooler, and remove the clip.5. Remove four bolts (2), and remove marine gear oil cooler (3).6. Remove the gasket and O-ring seal from oil cooler (3). The following steps are for installation of the marine gear oil cooler.7. Put the gasket and O-ring seal in place on the marine gear oil cooler. Put clean engine oil on the O-ring seal.8. Put marine gear oil cooler (3) in position on the engine, and install bolts (2).9. Put clip (4) in position on the oil cooler, and install the two bolts that hold it.10. Install tube (1) between the turbocharger and the marine gear oil cooler.11. Connect the oil inlet and outlet lines.12. Fill the cooling system with coolant to the correct level. See the Operation & Maintenance Manual.