V-BELT SET 3017510 - Caterpillar

Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient.
Ether Starting Aid
Ether Starting Aid - The ether starting aid is continuously available to the engine for cold weather starting. The engine ECM will determine automatically when the premeasured amount of ether injects the engine air intake. This action will occur during the engine starting procedure.
Illustration 1 g03419300For starting below −18°C (0°F), the use of the cold weather starting aids is recommended. A fuel heater, a jacket water heater, and extra battery capacity may be required.At temperatures below −23°C (−10°F), consult your Cat dealer. For information on starting the engine in cold weather, refer to the Operation and Maintenance Manual, SEBU5898, "Cold Weather Recommendations for all Caterpillar Machines".Subsequent Engine Starting Procedures
Keep engine speed low until the engine oil pressure registers on the gauge or the engine oil indicator light goes out.If it does not register or the light does not go out within ten seconds, stop the engine and investigate the cause before starting again. Failure to do so, can cause engine damage.
Allow a cold engine to warm up at low idle for at least 5 minutes.
You can begin to operate the machine with a reduced load.
When the oil pressure reaches the normal operating range and the temperature gauge begins to move, you may operate the machine at full load.
Monitor the lights and the gauges frequently during operation.
Check oil levels in the power train, the engine, and the hydraulic systems when the oil is at operating temperature. Maintain the oil levels to the FULL marks.