V-BELT 5046050 - Caterpillar

Work tool open and close speed can be decreased by lowering the following parameter value.
Spool shift pressure adjustment to extend the attachment control valves."Atch #1 Max Ext Press" (Parameter #30) - XXXX [kPa]"Atch #2 Max Ext Press" (Parameter #40) - XXXX [kPa]
Spool shift pressure adjustment to retract the attachment control valves for two-way flow only."Atch #1 Max Ret Press" (Parameter #31) - XXXX [kPa]"Atch #2 Max Ret Press" (Parameter #41) - XXXX [kPa]Note: For reference, this parameter is set within the range of 800 kPa to 2000 kPa. A parameter setting for spool shift pressure of 0 kPa is not made for flow from two pumps.Pump Flow to the Work Tool (Multiple Operation)
One Pump Flow
Set the additional flow to the work tool when multiple operations are to take place by using the following parameter settings."Atch #1 Mult-Ope Add Flow Setting" (Parameter # 28) - XXX [L/min]Note: Pump flow to the work tool may exceed the upper limit flow set (Parameter #27) when setting additional flow for multiple operation.
Setting the following parameters will enhance the work tool operation along with other implement movement.
Spool shift pressure adjustment to extend the attachment control valve."Atch #1 M-Ope Max Ext Press" (Parameter #32) - XXXX [kPa]
Spool shift pressure adjustment to retract the attachment control valve for two-way flow only."Atch #1 M-Ope Max Ret Press" (Parameter #33) - XXXX [kPa]Note: For reference, this parameter is set within the range of 800 kPa to 2000 kPa.Two Pump Flow
Set the additional flow to the work tool when multiple operations are to take place by using the following parameter settings."Atch #1 Mult-Ope Add Flow Setting" (Parameter # 28) - XXX [L/min]Note: Pump flow to the work tool may exceed the upper limit flow set (Parameter #27) when setting additional flow for multiple operation.
Setting the following parameters will enhance the work tool operation along with other implement movement.
Spool shift pressure adjustment to extend the attachment control valve."Atch #1 M-Ope Max Ext Press" (Parameter #32) - XXXX [kPa]"Atch #2 M-Ope Max Ext Press" (Parameter #42) - XXXX [kPa]
Spool shift pressure adjustment to retract the attachment control valve for two-way flow only."Atch #1 M-Ope Max Ret Press" (Parameter #33) - XXXX [kPa]"Atch #2 M-Ope Max Ret Press" (Parameter #43) - XXXX [kPa]Note: For reference, this parameter is set within the range of 800 kPa to 2000 kPa. A parameter setting for spool shift pressure of 0 kPa is not made for flow from two pumps.Enhanced Multiple Operation for Two Pump Flow
When operating the work tool with combined pump flow along with other functions (boom, stick, and swing), the control of the work tool can be improved using the following.Note: This parameter setting is only available when "Multi Ope Atch Valve Limit" (Parameter # 14) is Enabled.
The speed of the work tool when operating multiple functions at the same time can be increased or decreased. Increase the value of parameter to increase the speed. Decrease the value of the parameter to decrease the speed.
Spool shift pressure adjustment to extend the attachment