V-BELT SET 5297673 - Caterpillar

Start By:
Remove the piston pump (propel pump). Refer to Disassembly and Assembly, "Piston Pump (Propel Pump) - Remove".
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Conditioner contains alkali. Avoid contact with skin and eyes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Disconnect the negative battery cable.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
Illustration 1 g01310639
Loosen the clamps and disconnect hose (1) from the air cleaner housing and the engine.
Loosen the clamps and disconnect hose (2) from the radiator and the engine.
Illustration 2 g01314082
Loosen the clamp and disconnect hose (3) from the radiator.
Illustration 3 g01313794
Move harness assembly (4) out of the way.
Remove the bolts and remove guard (5) .
Illustration 4 g01313795
Remove the nut and disconnect harness assembly (6) from the engine.
Illustration 5 g01313796
Loosen the clamps and disconnect hoses (7) from the fuel filter assembly.
Loosen the clamp and disconnect hose (8) from the engine.
Loosen the clamp and disconnect hose (9) from the fuel pump.
Loosen the clamp and disconnect hose (10) from the engine.
Illustration 6 g01313797
Note: A typical example
Remove nut (11). Remove the bolts from bracket (12) and move cable assembly (13) out of the way.
Illustration 7 g01313798
Remove bolt (14) and move hoses (7) out of the way.
Disconnect harness assemblies (15) and move harness assembly (4) out of the way.
Illustration 8 g01313799
Disconnect hose assembly (16) and hose assembly (18) from hydraulic filter assembly (19) .
Remove bolts (17) and hydraulic filter assembly (19) .
Remove bolts (20) and bracket (21) .
Illustration 9 g01314183
Illustration 10 g01314479
Attach a suitable lifting device and Tooling (A) to engine (22). Remove bolt (23) from both sides of the engine. Remove bolt (24) and remove the engine from the machine. The weight of the engine is approximately 333 kg (735 lb).