V-BELT 9L6645 - Caterpillar

Flywheel Operating Parameters
Flywheel Common Operating Parameters
DEFAULT VALUES ARE FOR GENERAL INFORMATION ONLY. ACTUAL DEFAULTS MAY DIFFER DEPENDING ON SYSTEM CONFIGURATIONS, INSTALLATION SITES AND LOCAL CODES. CHECK EACH INDIVIDUAL UNIT FOR PROPER DEFAULTS.
Table 1
Name     Min     Max     Default     50 Hz Default     Modify from GUI?     Definitions    
DC Regulation Voltage     200     1125     735     685     Yes     Sets the DC bus voltage during discharge.    
DC Hi Volt Shutdown     500     1125     1125     1125     No     Sets the high DC bus voltage shutdown level.    
DC Low Volt Shutdown     200     1125     600     550     No     Sets the low DC bus voltage shutdown level.    
Motor Ramp Down Factor     0     10     5     5     No     Defines the end-of-motoring ramp-down. A lower number produces a faster ramp down (steeper step unload) at the end of motoring.    
Number Of Flywheel Cabinets     1     4     2     2     No     (Product configuration parameter) Defines the number of Flywheel Cabinets of the UPS system.    
Def. Data Log Rate     1     7200     600     600     Yes     Sets the time in seconds that telemetry will be written to the UPS View data log files if a computer is connected.    Flywheel Unique Operating Parameters
Table 2
Vacuum Warning Enable     0     1     0         Yes     Determines whether the vacuum warning message is green (0) or yellow (1)    
A,B: Mtring Bearing Force     100     650     350         No     Sets the amount of magnetic lifting force that is applied to the rotor of the flywheel when the flywheel is being motored.    
Vac. Sensor on Top FW     0     1     1         No     Indicates which flywheel interface PWA (FWI) has the vacuum sensor connected to which flywheel.    
Stndalne. Avl. Charg. Cur     10     1000     200         No     This parameter is no longer valid.    
ALT Stdaln Avl. Chrg. Cur     10     465     330         No     This parameter is no longer valid.    
CS View Baud Rate     9600     115200     38400         Yes     Set the UPSView serial baud rate for the Flywheel Cabinet service port.    
Internal CAN Enable     0     1     0         No     Enables the CAN network which is used for communication between APCs. (UPS and Flywheel Cabinets) This parameter should always be set to "1".    
Internal CAN Node ID     1     4     1         No     Sets the unique network number for each Flywheel Cabinet. Each Flywheel Cabinet requires a unique ID and should be numbered sequentially from 1 to the total (2,3,4) number of Flywheel Cabinets in the UPS system.    
CSNet Enable     0     1     1         No