V-BELT SET 9L6648 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00691836
Remove bolts (2), crankshaft vibration damper (3), and spacers from the crankshaft pulley. Note: For information on the reusability of the vibration damper on 3114 and 3116 engines, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8220, "Specifications for Damper Inspection 3114 and 3116 Engines".
Loosen the tension on water pump drive belt (1). Remove the belt from the crankshaft pulley.
Illustration 2 g00691831
Remove bolts (4) and the washers.
Remove crankshaft pulley (5). Note: For information on the reusability of the crankshaft pulley, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8046, "Cast Iron and Steel Pulleys".Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g00691831
Position crankshaft pulley (5) on the crankshaft. Install bolts (4) and tighten the bolts to a torque of 160 30 N m (118 22 lb ft). Note: For information on the reusability of the crankshaft pulley, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8046, "Cast Iron and Steel Pulleys".
Illustration 4 g00691836
Install water pump drive belt (1). Note: Check the alignment marks on the rubber vibration dampers for proper alignment. The rubber vibration damper should be replaced if the rubber vibration damper is out of alignment. Refer to Specifications, "Vibration Damper".
Install spacers and crankshaft vibration damper (3). Tighten bolts (2) to a torque of 55 10 N m (40 7 lb ft). Note: For information on the reusability of the vibration damper on 3114 and 3116 engines, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8220, "Specifications for Damper Inspection 3114 and 3116 Engines".
Adjust the tension of water pump drive belt (1). Refer to the Specifications Module, "Belt Tension Chart". Also, refer to the Operation and Maintenance Manual, "Belt - Inspect".