VALVE 0009570 - Caterpillar

Illustration 1 g01297059
Back Cushion Angle Adjustment (1) - Pull the lever upward. Permit the back cushion spring forward or lean backward into the cushion. Release the lever at the desired position.
Fore and Aft Position (2) - Pull the lever upward. Move the seat in the desired direction. Release the lever at the desired forward position or the desired rearward position.
Ride Indicator (3) - Use this indicator in order to determine if the suspension is adjusted too high or the adjustment is too low. When the operator sits in the seat, the white bar should be in the green zone.
Seat Height (4) - Push in the knob in order to raise the seat height. Pull out on the knob in order to lower the seat height. Note: The engine start switch key must be turned ON or the engine must be running in order to adjust the height of the seat.
Heated Seat (5) (If equipped) - Press the rocker switch in order to activate the seat heater. A red light will turn ON.
Seat Cushion Tilt (6) - The front of the seat cushion is pinned in a groove. Grasp the seat pan and rotate "forward-up-and-back" into the steep angle position. Grasp the seat pan and rotate "forward-down-and-back" into the nominal angle position.
Lumbar Support (7) - Rotate the knob counterclockwise in order to increase lumbar support. Rotate the knob clockwise in order to decrease lumbar support.
Back Extension (8) - Pull up on back extension in order to remove the back extension.