VALVE GP 0928997 - Caterpillar

Work tool open and close speed can be decreased by lowering the following parameter value.
Spool shift pressure adjustment to extend the attachment control valve."Atch #X Max Ext Press" (Parameter #30 and #40) - XXXX [kPa]
Spool shift pressure adjustment to retract the attachment control valve for two-way flow only."Atch #X Max Ret Press" (Parameter #31 and #41) - XXXX [kPa]Note: For reference, this parameter is set within the range of 800 kPa to 2000 kPa.Two Pump Flow
Set the appropriate flow for the work tool to be installed by using the following parameter settings."Atch #1 Flow Setting" (Parameter # 27) - XXX [L/min]
Table 2
Maximum Flow Setting for Two Pump Flow
349E / 349F 770 L/min (203.4 US gal/min)
336E / 336F 578 L/min (152.7 US gal/min)
329E / 329F / 330F 494 L/min (130.5 US gal/min)
326F 462 L/min (122.0 US gal/min)
324E 462 L/min (122.0 US gal/min)
323E / 320E / 320E N / 323 E N / 320E RR 428 L/min (113.1 US gal/min)
320F / 323F N 422 L/min (111.5 US gpm)
323F 418 L/min (110.4 US gpm)
318E / 316E / 318F / 316F 300 L/min (79.3 US gal/min)
314E CR / 314F / 315F 256 L/min (67.6 US gal/min)
312E / 312F / 313F 256 L/min (67.6 US gal/min)
Work tool open and close speed can be decreased by lowering the following parameter value.
Spool shift pressure adjustment to extend the attachment control valves."Atch #1 Max Ext Press" (Parameter #30) - XXXX [kPa]"Atch #2 Max Ext Press" (Parameter #40) - XXXX [kPa]
Spool shift pressure adjustment to retract the attachment control valves for two-way flow only."Atch #1 Max Ret Press" (Parameter #31) - XXXX [kPa]"Atch #2 Max Ret Press" (Parameter #41) - XXXX [kPa]Note: For reference, this parameter is set within the range of 800 kPa to 2000 kPa. A parameter setting for spool shift pressure of 0 kPa is not made for flow from two pumps.Pump Flow to the Work Tool (Multiple Operation)
One Pump Flow
Set the additional flow to the work tool when multiple operations are to take place by using the following parameter settings."Atch #1 Mult-Ope Add Flow Setting" (Parameter # 28) - XXX [L/min]Note: Pump flow to the work tool may exceed the upper limit flow set (Parameter #27)