VALVE 0948247 - Caterpillar

Illustration 21 g00719204
Install four plates (15) and bolts (16). Tighten the bolts to a torque of 55 7 N m (41 5 lb ft).Note: There must be metal to metal contact between the shafts and plates (15). Use a feeler gauge. Ensure that there is a gap of 0.08 0.05 mm (0.003 0.002 inch) between plates (15) and the surface of the carrier.
After four plates (15) have been installed, use a press to push the plates even with the surface of the carrier.
Illustration 22 g00719200
Use a strap and a suitable lifting device on carrier assembly (13) to lower the carrier assembly onto gear (14). The weight of the carrier assembly is approximately 100 kg (220 lb).
Illustration 23 g00719162
Put retaining ring (12) in position in the groove in the gear.
Illustration 24 g00720699
Put sun gear (14) in position in the planetary carrier. Use a wire (42) to hold the gear in position when the planetary carrier is installed in the final drive. Install the wire across the bottom of the gear from the outside of the planetary carrier.
Illustration 25 g00720704
Put retainer (10) and retaining ring (9) in position in gear (11) .
Install Tooling (A) on the gear. The weight of the gear is approximately 118 kg (260 lb). Use a suitable