VALVE GP-CHECK 1047108 - Caterpillar

Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (-) to battery negative (-).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
When starting from another machine, make sure that the machines do not touch. This could prevent damage to engine bearings and electrical circuits.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 12 volt starting system. Use only the same voltage for jump starting. Use of a welder or higher voltage damages the electrical system.Refer to Special Instruction, Battery Test Procedure, SEHS7633, available from your Caterpillar dealer, for complete testing and charging information.
Use of Jump Start Cables
When the auxiliary start receptacles are not available, use the following procedure.
Determine the failure of the engine to start. Refer to Special Instruction, SEHS7768 on the use of 6V-2150 Starting Charging Analyzer Group. Use this procedure if the machine does not have a diagnostic connector.
Place the direction control switch in the NEUTRAL position on the stalled machine. Engage the parking brake. Lower all attachments to the ground. Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped". Move all controls to the HOLD position.
On the stalled machine, turn the start switch key to the OFF position. Turn off the accessories.
On the stalled machine, turn on the battery disconnect switch (if equipped).
Move the machines together in order for the cables to reach. DO NOT ALLOW THE MACHINES TO CONTACT.
Stop the engine on the machine that is the electrical source. When you use an auxiliary power source, turn off the charging system. Open the engine hood. The remote terminal is located on the left side of the machine.
Check the battery caps for correct placement and for correct tightness. Make these checks on both machines. Make sure that the batteries in the stalled machine are not frozen. Check the batteries for low electrolyte.
Illustration 1 g01033179
902 7ES1-UP and 906 6ZS1-UP
Illustration 2 g00624084
908 8BS1-UP
Illustration 3 g01033166
906 MER1-UP and 908 TAR1-UP
The positive remote jump start terminal is located on the battery for the 902 7ES1-UP and 906, 6ZS1-UP machines. The positive remote jump start terminal is located on the left side of