VALVE AS 1074397 - Caterpillar

Conditions Which Generate This Code:
Illustration 1 g01362246
Connections of the inching pedal switchThis diagnostic code is associated with the inching pedal switch. The switch is connected to two inputs of the ECM. The inputs are "Normally Open" and "Normally Closed". One of the inputs is open and the other input is grounded during proper operation.The FMI 7 means that the ECM is receiving an improper response from the switch.Note: The following test procedure may create other diagnostic codes. Ignore these diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of SPN 702 FMI 7 is active before performing this procedure.Test Step 1. CHECK THE OPERATION OF THE SWITCH
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector or the wires from the switch.
Connect one lead from the multimeter to the common contact (COM) for the switch.
Connect the other lead from the multimeter to the normally open contact (NO) for the switch.
Measure the resistance between contact COM and contact NO. Note the resistance.
Disconnect the lead from contact NO and connect the lead to the normally closed contact (NC).
Measure the resistance between contact COM and contact NC. Note the resistance.Expected Result:The resistance from contact COM to contact NO is greater than 5000 ohms, and the resistance from contact COM to contact NC is less than 5 ohms.Results:
YES - The resistance from contact COM to contact NO is greater than 5000 ohms, and the resistance from contact COM to contact NC is less than 5 ohms. Proceed to Test Step 2.
NO - The resistance measurements do not differ. The switch has failed.Repair: Replace the switch.STOPTest Step 2. CHECK THE OPERATION OF THE SWITCH
Connect one lead from the multimeter to the common contact (COM) for the switch.
Connect the other lead from the multimeter to the normally open contact (NO) for the switch.
Actuate the switch and measure the resistance between contact COM and contact NO. Note the resistance.
Disconnect the lead from contact NO and connect the lead to the normally closed contact (NC).
Actuate the switch and measure the resistance between contact COM and contact NC. Note the resistance.Expected Result:The resistance from contact COM to contact NO is less than 5 ohms, and the resistance from contact COM to contact NC is greater than 5000 ohms.Results:
YES - The resistance from contact COM to contact NO is less than 5 ohms, and the resistance from contact COM to contact NC is greater than 5000 ohms. Proceed to Test Step 3.
NO - The resistance measurements do not differ. The switch has failed.Repair: Replace the switch.STOPTest Step 3. CHECK THE GROUND CIRCUIT OF THE SWITCH IN THE WIRE HARNESS.
Connect one lead from the multimeter to contact COM (wire J766-PU) of the wire harness connector for the switch.
Connect the other lead from the multimeter to frame ground.
Measure the resistance between contact COM (wire J766-PU) and frame ground.Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms.