VALVE GP-FLOW DIVIDER 1129049 - Caterpillar

Illustration 13 g06249041Note: Measure adjustment screws (37) for assembly purposes.
Remove nuts (36). Remove set screws (37A) and (37B) from head assembly (30).
Illustration 14 g06248257
Remove bias actuator (38), spring (40), control actuator (39), and O-ring seal (41) from pump housing (43).
Rotate housing (43) to a horizontal position and remove rotating group (42).
Illustration 15 g06248259
Remove pistons (44) and retainer (45) from barrel (46).
Illustration 16 g06248271
Remove hold down ball (47) from barrel (46).
Illustration 17 g06248276
Remove shims (48) and springs (49) from barrel (46).
Illustration 18 g06248290
Remove swashplate (50) from housing (43).
Illustration 19 g06248295
Remove bearing assemblies (51) from swashplate (50).
Illustration 20 g06248297
Remove bolts (53), retainers (54), and actuators (52) from swashplate (50).
Illustration 21 g06248472
Remove bearings cradles (55) from housing (43).
Illustration 22 g06248487
Illustration 23 g06248490
Rotate the pump to access the seal retainer. Remove bolts (56).
Use Tooling (C) to remove seal retainer (57) from the pump housing.
Illustration 24 g06248624
Remove lip seals (58), O-ring seal (59), and O-ring seals (60) from seal retainer (57).
Illustration 25 g06248509
Use a soft faced hammer to remove shaft assembly (61) from pump housing (43).
Illustration 26 g06248511
Remove retaining ring (62) from shaft assembly (61). Use a suitable press to remove bearing (63) from shaft assembly (61).
Illustration 27 g06248513
Remove plug (64) and the O-ring seal. Remove plug (65) and the O-ring seal. Remove bolts (66) and cover (67) from pump housing (43).
Illustration 28 g06248518
Remove O-ring seal (68) from cover (67).