VALVE GP-BANK 6 1151008 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
C 1U-3052 O-ring assembly compound 1
D 4C-4030 Thread Lock Compound 1
E 155-0695 Thread Lock Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean the faces of the pump housing and the front housing.
Illustration 1 g01530747
If necessary, install studs (8). Apply Tooling (E) to the threads of studs (8). Install studs to the housing and tighten securely.
Lubricate a new O-ring seal (4) with Tooling (C). Install the O-ring seal to auxiliary water pump (1).
Install auxiliary water pump (1) to the front housing. Slide bracket (3) into position on mounting studs (8). Ensure the correct orientation of the auxiliary water pump.
Install spacer (5). Apply Tooling (D) to bolt (6). Install the bolt finger tight. Install nuts (9) finger tight. Tighten nuts and bolts to a torque of 22 N m (16 lb ft).
Connect the hose to connection (2) on auxiliary water pump (1).
Connect the hose to connection (7) on auxiliary water pump (1).
Turn the drain valve for the sea water circuit to the ON position.
Turn the battery disconnect switch to the ON position.
Run the engine and check for leakage at the auxiliary water pump and at the hose connections. Check that water is being expelled from the exhaust pipe. Note: Do not run the auxiliary water pump in a dry condition. The impeller blades of the auxiliary water pump will be damaged.