VALVE GP-BYPASS 1282034 - Caterpillar

Illustration 1 g00104135
Remove the bolts that secure the access cover. Remove the crankcase access cover.Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
Illustration 2 g00104175
Open the crankcase drain valve. Allow the oil to drain into a suitable container.Note: Discard any drained fluids according to local regulations.
Close the drain valve.
Install the crankcase access cover.
Illustration 3 g00103944
Unlatch the engine hood and raise the engine hood.
Illustration 4 g00104145
Open drain valve (1) located on the bottom of oil filter (2). Allow the remaining engine oil to drain into a suitable container.
Close drain valve (1) .
Remove the oil filter. Inspect the used oil filter. See Operation and Maintenance Manual, "Oil Filter - Inspect" for further information. Discard the used oil filter properly.Note: The oil filter is a cartridge type filter. The used oil filter cannot be reused.
Clean the filter housing base. Make sure that all of the old filter gasket is removed.
Illustration 5 g00101634
Apply a thin coat of engine oil to the gasket of the new filter.
Install the new filter by hand. When the gasket contacts the filter base, turn the filter by 270 degrees more. This will tighten the filter sufficiently.Every new oil filter has rotation index marks that are spaced at 90 degree increments. Use the rotation index marks as a guide for tightening the oil filter.
Illustration 6 g00104177
Remove oil filler plug (4). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Refill Capacities" for the proper amount of engine oil. Clean the oil filler plug and install the oil filler plug.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Run the engine at low idle for two minutes. Check the engine for leaks. Stop the engine.
Illustration 7 g00104116
Wait for thirty minutes in order to allow the oil to drain back into the crankcase. Check the oil level with dipstick (3). Maintain the oil between the "H" and "L" marks on the dipstick. If necessary, add more oil.