VALVE & MTG GP-SOLENOID 1381979 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Illustration 1 g00456570Drain plug (2) for the differential is located under the transmission of the tractor. Drain plug (1) for the transmission is located behind drain plug (2). Drain plug (2) is located closer to the front of the machine.Operate the machine until the differential oil is warm. Park the machine on a level surface. Lower the bowl.
Engage the parking brake. Stop the engine.
Clean the area around drain plug (2).
Remove drain plug (2) and drain the oil into a suitable container.
Clean drain plug (2). Install drain plug (2).
Illustration 2 g00873649Note: Drain plug (3) for the final drive is located on the hub of the wheel. Drain plug (3) must be at the lowest point for the plug in order to drain the final drive.
Clean the area around drain plug (3).
Remove drain plug (3). Drain the oil into a suitable container.
Clean drain plug (3). Install drain plug (3).
Repeat this procedure for the other wheel.
Illustration 3 g00473367Note: Filler tube (5) for the differential is located at the right rear of the tractor.
Clean the area around filler tube (5). Remove the cap.
Fill the differential with oil through the filler tube. Fill the differential to the "FULL" mark in the sight glass (6). Refer to Operation and Maintenance Manual, "Capacities (Refill)" and Operation and Maintenance Manual, "Lubricant Viscosities" for further information.
Clean the filler cap. Install the filler cap. Note: The differential and the final drives share a common reservoir. However, the oil level of the final drives should be checked. The filler plug for the final drive must be horizontal with the center of the final drive in order to check the oil level of the final drive. Drain plug (3) will be at the bottom of the wheel.
Clean the area around filler plug (4). Remove filler plug (4).
Add oil to the final drive if oil is needed. Oil should be dripping out of the filler hole when the final drive is full of oil.
Clean filler plug (4). Install filler plug (4).