VALVE GP-RELIEF 1417812 - Caterpillar

Illustration 1 g00517098
Remove bolt (1), the washer, and the spacer from pin assembly (2).
Illustration 2 g00517100
Attach a suitable lifting device to the rod end of tilt cylinder (3).
Attach a suitable lifting device to Tooling (A). Use Tooling (A) in order to remove pin assembly (2).
Illustration 3 g00517366
Start the machine. Retract the cylinder rod. Lower tilt cylinder (3) on the front loader frame, as shown.
Illustration 4 g00517369
Remove bolt (4), the washer, and the spacer from pin assembly (5).
Illustration 5 g00517371
Attach a suitable lifting device to tilt link (6). Attach a suitable lifting device to Tooling (A). Install Tooling (A) on pin assembly (5). Remove pin assembly (5). Lower tilt link (6) to the floor.
Illustration 6 g00517444
Illustration 7 g00517504
Remove bolt (7), the washer, and the spacer from pin assembly (8).
Attach a suitable lifting device to tilt lever (9).
Attach a suitable lifting device to Tooling (B). Install Tooling (B) on pin assembly (8). Remove pin assembly (8). The weight of pin assembly (8) is 27 kg (60 lb).
Illustration 8 g00517505
Remove tilt lever (9) and the tilt link as a unit. The combined weight of tilt lever (9) and the tilt link is approximately 352 kg (775 lb).
Illustration 9 g00517512
Remove bolt (10), the washer, and the spacer from pin assembly (11).
Illustration 10 g03494699
Attach a suitable lifting device to Tooling (A). Install Tooling (A) on pin assembly (11). Remove pin assembly (11). Remove tilt link (12). The weight of tilt link (12) is approximately 57 kg (125 lb).
Illustration 11 g00517532
Remove four lip seals (13) from tilt link (12).
Illustration 12 g03494718
Install Tooling (C) on tilt link (12), as shown. Remove sleeve bearing (14) (not shown), from each end of tilt link (12).
Illustration 13 g03494736
Remove lip seals (15) from tilt lever (9).
Illustration 14 g03494257
Use Tooling (D) in order to remove sleeve bearing (16) (not shown), from tilt lever (9).