VALVE-CHECK 1438997 - Caterpillar

Warning Signs And Labels
There are several specific safety signs on your transfer switch. Their exact location and description of the hazard are reviewed in this section. Please take the time to familiarize yourself with these safety signs.Make sure that you can read all safety signs. Clean and replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvent, gasoline, etc.You must replace a label if it is damaged, missing or cannot be read. If a label is on a part that is replaced, make sure a new label is installed on the replaced part. See your Caterpillar dealer for new labels.
Do not operate the equipment unless you have read and understand the instructions in this manual. Improper operation is dangerous and could result in injury or death. Contact any Caterpillar dealer for a replacement guide. Proper operation is your responsibility.
Installation
All electrical equipment supplied by Caterpillar should be installed in accordance with the Application and Installation Manual, form LEBX5048 and conform to national and local electrical codes of the area and county where the equipment is operating.Any generator that is used for backup power in the event of a normal power source failure must be installed in conjunction with a transfer switch. Failure to isolate the normal and standby power sources from each other may result in damage to the standby generator and may also result in injury or death to electric utility workers, due to backfeed of electrical energy.Improper or unauthorized installation, operation or repair of this equipment is extremely dangerous and may result in death, serious personal injury, or damage to equipment and/or property.General Hazard Information
Do not allow unauthorized or untrained personnel on or near equipment.Do not wear loose clothing or jewelry while working around equipment.Stop the engine before making adjustments or repairs to the engine or generator transfer switch unless otherwise specified.Be sure the remote starting system is inoperative on the equipment being serviced.Disconnect and tape the battery ground lead or move the automatic start-up switch to the STOP position before working on the equipment. Doing this will prevent accidental starting.To prevent injury, install guards over all exposed drive shafts, pulleys and any application with exposed rotating parts.Always use tools that are in good condition and be sure you understand how to use them before performing any service work. Remove all tools, electrical cords and any other loose items from the engine before starting.Engine speeds, temperatures and load are the best indications of performance. Rely on your instruments, record and compare readings to detect developing abnormalities.Wear a hard hat, face shield, clothing, shoes, respirator or other protective items when necessary.When using pressure air, always use approved safety equipment.To prevent hearing damage, wear ear protective devices if working inside an enclosed engine room with engine running.Never work on this equipment while physically or mentally fatigued.Keep the transfer switch door closed and locked at all times. Only authorized personnel should be permitted access