VALVE GP-CONTROL 1711970 - Caterpillar

Illustration 9 g01310416
Video Input Terminal
The video input terminal is attached to the harness for the monitor. Refer to Illustration 9. Remove the cap in order to connect the video output terminal with the RCA jack.Note: Take adequate measurements in order to prevent disconnection of the terminals. Also, use heat shrink tube in order to keep water out of the terminals.If an electrical supply is required for the camera, a 24V source is available. Access (wire 180-GN(Green)) that is located in the fuse box. The fuse box is located behind the operator seat. Refer to the following illustration . This 24V source is tied to the engine key switch.
Illustration 10 g01310417Monitor Settings
The Video Mode Setting Menu allows the operator to setup the monitor for the camera image.Press the "menu" key in order to display the Main Menu. Press the "left" key or "right" key in order to highlight the Setting Menu. Press the "OK" key.
Illustration 11 g01310700
Main Menu
The "Setting" Menu will be displayed as shown in Illustration 12.
Illustration 12 g01310705
Setting Menu
Press the "Down" Key in order to move the cursor to the "Video Mode Setting" Option. When the "Video Mode Setting" is highlighted, press the "OK" button.
Illustration 13 g01310709
Password Menu
The "PASSWORD" menu will be displayed. Press the "left" key or the "right" key in order to highlight the desired character. Then press the "OK" key in order to set the desired character. Press the "back" key in order to delete a selected character. The initial user password is "0001" and the service password is "FFF2".Note: The password may have been changed by the user.
Illustration 14 g01310741
Video Mode Setting
If the password is correct, the user will be allowed access to the "VIDEO MODE SETTING" menu as shown in Illustration 14. Press the "up" key or "down" key in order to move the cursor to the desired item. When the desired item is highlighted, press the "OK" key in order to set your selection. The user is now allowed to change the selected item.
Illustration 15 g01310745Press the "up" key or "down" key in order to change the settings. After the settings are changed, press the "OK" key in order to set the new settings. The new settings will be saved to memory.When the "VIDEO MODE SETTING" menu is displayed and the "left" key is held, the video camera image can be displayed on the monitor temporarily. This will allow the operator to check the display status with the new settings.Note: The following is an additional method to change the settings. Hold down the left key and press the up key and down key at the same time in order to change the item. When the desired item to change has been selected, press the "OK" key in order to confirm the selection. Use the "UP/DOWN" key in order to change the settings to the desired value. Press the "left" key in order to temporarily view the camera image with the new settings. Press the "LEFT" key and the "UP/DOWN" key at the same time in order to make