VALVE GP-TRANSMISSION CONTROL 1796063 - Caterpillar

Removal Procedure
Start By:
Remove the cylinder head assembly. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01255067
Typical example
Remove gasket (3), seals (1), seals (2), and O-ring seal (4) from the spacer plate.
Illustration 2 g00583156
Typical example
Remove spacer plate (5) from the dowels in the cylinder block.
Illustration 3 g00583157
Typical example
Remove gasket (6) from the dowels.
Illustration 4 g00583158
Typical example
Remove the O-ring seal from dowel (7). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the spacer plate and the surface of the cylinder block are clean.
Illustration 5 g00583158
Typical example
Install the O-ring seal on dowel (7).
Illustration 6 g00583157
Typical example
Ensure that the surface of the spacer plate gasket and the surface of the cylinder block are clean. Do not use a gasket adhesive on these surfaces.
Install a new gasket (6) on the dowels in the cylinder block.
Illustration 7 g00583156
Typical example
Install spacer plate (5) on the dowels.
Illustration 8 g01255067
Typical example
Install new seals (1) and (2) in the spacer plate.
Install new O-ring seal (4) on the dowel.
Check the cylinder liner projection. Refer to Testing and Adjusting, "Cylinder Liner Projection".
Install new gasket (3) on top of the spacer plate. End By:
Install the cylinder head assembly. Refer to Disassembly and Assembly, "Cylinder Head - Install".