VALVE GP-BANK 5 1809632 - Caterpillar

To prevent damage to engine bearings and to electrical circuits when you jump start a machine, do not allow the stalled machine to touch the machine that is used as the electrical source.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.Use only equal voltage for starting. Check the battery and starter voltage rating of your machine. Use only the same voltage for jump starting. Use of a welder or higher voltage damages the electrical system. This machine has a 24 volt starting system. Use only the same voltage for jump starting.Refer to Special Instruction, SEHS7633, "Battery Test Procedure" available from your Caterpillar dealer, for complete testing and charging information.
Engage the parking brake. Lower the work tools to the ground. Reference: Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped".
Move all control levers to the HOLD or NEUTRAL position.
Turn the engine start switch key to the OFF position and turn all accessory switches to the OFF position.
Move the machine that is being used as an electrical source near the stalled machine so that the jump start cables reach the stalled machine. Do not allow the machines to contact each other.
Stop the engine of the machine that is being used as an electrical source. If you are using an auxiliary power source, turn off the charging system.
Ensure that battery caps on both machines are tight and correctly placed. Ensure that batteries in the stalled machine are not frozen.
Connect the positive jump start cable to the positive cable