VALVE GP-PUMP CONTROL 1845173 - Caterpillar

Data Broadcasts
Data concerning this machine, the condition of the machine, and the operation of the machine is being transmitted by Product Link to Caterpillar and/or Cat dealers. The data is used to serve the customer better and to improve upon Caterpillar products and services. The information transmitted may include: machine serial number, machine location and operational data, including but not limited to: fault codes, emissions data, fuel usage, service meter hours, software and hardware version numbers and installed attachments.Caterpillar and/or Cat dealers may use this information for various purposes. Refer to the following list for possible uses:
Providing services to the customer and/or the machine
Checking or maintaining Product link equipment
Monitoring the health of the machine or performance
Helping maintain the machine and/or improve the efficiency of the machine
Evaluating or improving Caterpillar products and services
Complying with legal requirements and valid court orders
Performing market research
Offering the customer new products and servicesCaterpillar may share some or all of the collected information with Caterpillar affiliated companies, dealers, and authorized representatives. Caterpillar will not sell or rent collected information to any other third party and will exercise reasonable efforts to keep the information secure. Caterpillar recognizes and respects customer privacy. For more information, please contact your local Cat dealer.Operation in a Blast Site for Product Link
The Product Link radio transmitter must be disabled by the minimum distance mandated under all applicable legal requirements. The following is the Caterpillar recommended distance from the site, whichever is greater: 12 m (40 ft) for Product Link 121SR and 321SR and 3 m (10 ft) for Product Link 420/421 and 522/523. The following are suggested methods to disable the Product Link 121SR system or the Product Link 522/523 system: (a) Install a Product Link disconnect switch in the machine cab that will allow the Product Link 121SR system or the Product Link 522/523 system module to be shut off. Refer to Special Instruction, REHS2365, "An Installation Guide for the Product Link PL121SR and for the PL300" and Special Instruction, REHS2368, "Installation Procedure For Product Link PL522/523 (Cellular)" for more details and installation instructions. Or, (b) Disconnect the Product Link 121SR system or the Product Link 522/523 module from the main power source by disconnecting the wiring harness at the Product Link module.For Product Link devices with an internal battery back-up without a radio disable feature including the PL420 system: Do not operate an asset with this type of device within a blast site. Do no operate within the minimum mandated or recommended distance from a blast site perimeter.The following Product Link system specifications are provided to aid in conducting any related hazard assessment and to ensure compliance with all local regulations:
The transmit power rating for the Product Link 121SR transmitter is 5 to 10 W.
The operating frequency range for the Product Link 121SR system is 148 to 150 MHz
The transmit power rating for the Product Link 522/523 transmitter is approximately 1 W.
The operating frequency range for the Product Link 522/523 system is 824 to 849 MHz, 880 to 915