VALVE GP-CHECK 1850208 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
Illustration 1 g01025389
Illustration 2 g01025397
Attach Tooling (A) and a suitable lifting device to track motor (1). Position track motor (1) under the tractor.
Check that the O-ring seal (3) and the O-ring seal on the shaft in the final drive are in place. Put oil on the O-ring seals.
Use Tooling (A) in order to position track motor (1) in the machine. If the splines are not aligned, put the splines into alignment by turning the track motor. Install the four bolts that fasten track motor (1) to the frame. Tighten the bolts to a torque of 360 50 N m (265 37 lb ft). Remove Tooling (A) and the suitable lifting device from track motor (1) .
Illustration 3 g00726469
Connect governor control linkage (4) to governor control lever (5) .
Illustration 4 g00726470
Fasten clamp (6) to the bracket with bolt (7) .
Illustration 5 g00726471
Connect hose assembly (8) to the top of the track motor.
Illustration 6 g00726473
Connect hose assembly (9). Check that the O-ring seal is in place on the end of hose assembly (10). Connect hose assembly (10) to the track motor with two flanges and four bolts.
Illustration 7 g00726474
Connect hose assembly (11) to the track motor with two flanges and four bolts.
Illustration 8 g00726475
Install side support (12). Use a floor jack to install center support (13). The weight of center support (13) is approximately 27 kg (60 lb). Tighten the bolts that hold the side and center support to the frame to a torque of 135 15 N m (100 11 lb ft).
Install the two center bottom guards. The weight of each center bottom guard is approximately 33 kg (73 lb). Fill the transmission to the correct level with clean SAE 10 oil.End By: Lower the cab into position.